Hi
I’ve got a strange noise coming from the front brakes sort of a rattle or
rumble like noise and fairly loud.
This only occurs when applying the brakes hard at higher speeds 100kms to
120kms.
The dealer told me it was warped disks so I had pads and disks replaced also
wheel bearings , the brakes where checked and the problem still occurs.
Note the car has no ABS so its not the anti skid.
There is no other noise or vibration when this happens.
The dealer does not want to test the car over the speed limit and has not
heard the noise only my limited discription.
Any ideas ? before I go back to the dealer and get "taken for another ride"
Thanks
01
Feb
Sonata 2003 brake noise
60MPH (100kph) doesn’t sound too terribly over the speed limit (if at all).
If the noise happens consistently at this speed and they refuse to test it
as such, seek out a place that will.
Your description sounded like warped rotors to me. Are you sure it’s the
front? Might it be the rear? Has the suspension/steering been checked
for wear?
Thanks for the reply.
I also thought it was the rotors also but it was a no fix after they
replaced them.
Are the brakes normaly Installed with an Anti Rattle device ? What does it
look like and would there be any reason they would not install it ?
I’m almost certain its from the front I feel no vibration or front end noise
as I said only when applying the brakes hard.
Yes 100-120 km is not far over the limit I think the dealer is just too lazy
to take it on the highway.
As you say I’ll take it to another dealer.
"hyundaitech" <notpub…@not.public.com> wrote in message
news:90b83b8e0987f1c5bb9234f3205d3290@localhost.talkaboutautos.com…
- Hide quoted text — Show quoted text -
> 60MPH (100kph) doesn’t sound too terribly over the speed limit (if at
all).
> If the noise happens consistently at this speed and they refuse to test
it
> as such, seek out a place that will.
> Your description sounded like warped rotors to me. Are you sure it’s the
> front? Might it be the rear? Has the suspension/steering been checked
> for wear?
The pads should insert onto two pieces of spring metal in each caliper.
These hold the pads tight and reduce rattle and squeal. There are also
shims on the back of the pads which help reduce squeal.